Now that the tilt over mount is in place, it’s time to attach the pole. I eyeballed the tube lining up with the bracket. The clamps attach to the support slightly offset to one side. Staring at the picture, you have to remember this misleads about where the tube is Read more…
Now that hardware is all cleaned up, we’re ready to go. Well, not so fast, it has been unhealthy outside for some time now. On hold for several weeks. Finally, the awful western U.S. wildfire smoke of 2020 has cleared out, and it’s time to do work again outside. Dry Read more…
A few weeks ago, I participated in a zoom call named ‘CW-CHAT.’ CW stands for continuous wave, by the way, which is another term for morse code transmissions. The zoom call is a sort of check-in and Q&A for anyone who wants to learn morse code and get feedback from Read more…
Time to recover from the galling incident. I bought new stainless hardware from ACE Hardware and replaced the fully threaded bolts with partially threaded. Perfect for 2″ OD tube. I don’t want to take the chance that these threaded bolts that come with the kit seize up again later. Dimensions Read more…
The foundation finished, and now it is time to get ready for the mast. DX Engineering’s OMNI-TILT will allow me to bring the mast down and walk it back up again. Because of SWMBO blessing requirements, I will paint the stainless brackets of the tilt assembly black to make it Read more…
When we lived in Atlanta, I had a half acre-sized backyard with big, mature trees that were great for hanging a half-wave 80m loop. We have been in the pacific northwest for a while now. Unfortunately, while we do have lots of trees on our lot, they are not in Read more…
