holdmybeer.io

omni-tilt

Recent Posts
  • Make Raspberry Pi 4 Fast
  • KiCAD 6 on Raspberry Pi OS
  • Heil RS-1 no-drill clamp mount
  • Antenna Part 7: Got pole?
  • Antenna Part 6: Hinged
Categories
  • Amateur Radio
  • Audio
  • KiCAD
  • Raspberry Pi
Archives
  • February 2021
  • January 2021
  • September 2020
  • July 2020
  • June 2020
Meta
  • Register
  • Log in
  • Entries feed
  • Comments feed
  • WordPress.org
Amateur Radio

Antenna Part 7: Got pole?

Now that the tilt over mount is in place, it’s time to attach the pole. I eyeballed the tube lining up with the bracket. The clamps attach to the support slightly offset to one side. Staring at the picture, you have to remember this misleads about where the tube is Read more…

By Christian, 5 months1 month ago
Amateur Radio

Antenna Part 3: Omnibus tiltibus

The foundation finished, and now it is time to get ready for the mast. DX Engineering’s OMNI-TILT will allow me to bring the mast down and walk it back up again. Because of SWMBO blessing requirements, I will paint the stainless brackets of the tilt assembly black to make it Read more…

By Christian, 8 months1 month ago
Amateur Radio

Antenna Part 2: Of bungees and concrete

It was time to pour the footing for the base of the mast and embed the Chromoly tube in the bottomless hole. Ingredients: 1x tube of painted, galvanized Chromoly (5′ 4″ x 2″ OD x 1/4″ wall) 5x 80 lbs of fiber concrete mix 1x 60 lbs of gravel 4x Read more…

By Christian, 8 months1 month ago
    holdmybeer.io | © 2020 Christian Kuhtz | AK7VV